Description

Quick-drying primer for wood, metal and aluminum

MoTip Primer is an effective and fast-drying primer used for pre-treatment of wood, metal, aluminum, glass and stone before applying the desired color. Not only does the primer ensure that the color binds better to the substrate, it also helps to even out irregularities in the surface and at the same time acts as a rust-protective layer. MoTip Primer can be sanded down both while it is wet and while it is dry, so it is not difficult to create an even and uniform result without stains and irregularities. MoTip Primer comes in a 500 ml can.

MoTip Primer – Your friend in need

If you need to repaint your scooter or just fix a few small scratches, then MoTip Primer may well be your friend in need. The primer provides a uniform surface with good adhesion, so you can once again proudly show off your shiny scooter.

Re-sprayable with all types of lacquer

Start by shaking the MoTip Primer thoroughly and apply a thin, even layer on a completely dry, clean surface at a distance of approximately 25-30 cm. Repeat as needed, paying attention to shaking the can between each layer. Allow the primer to dry afterwards. Drying time depends on temperature. humidity and thickness of the lacquer layer. Always clean the nozzle when you are done to make sure it does not stop. This is easily done by turning the can upside down, and then holding the nozzle inside for approx. 5 seconds.